5 V Analog input / 0V to +5V (Con A) 5 V Analog input / 0V to +5V (Con B)
Color Description Channel Color Description Channel
1 - Screen - 1 - Screen -
2 -- -2 -- -
3 Black 0 Volts - 3 Black 0 Volts -
4 Red 5V Supply - 4 Red 5V Supply -
5 SD Signal 0V to +5V Analog 1 5 SD Signal 0V to +5V Analog 4
6 SD Signal 0V to +5V Analog 2 6 SD Signal 0V to +5V Analog 5
7 SD Signal 0V to +5V Analog 3 7 SD Signal 0V to +5V Analog 6
8 -- -8 -- -
SD = Sensor depensdent
0 Volt to 5 Volt sensors can be wired into either Terminal A or Terminal B. If you plug
a 0 - 5 Volt analog input into Terminal 1 then the analog channels will be 1, 2 & 3, if
connected to Terminal 2 then they will be channels 4, 5 & 6.
Masthead unit Paddlewheel sensor
Color Description Color Description
1 - Screen 1 - Screen
2 Orange 12V Supply 2 --
3 Black 0 Volts 3 Black 0 Volts
4 --4 Red 5V Supply
5 Blue Wind angle Phase 5 --
6 Green Wind angle Phase 6 --
7 Red Wind angle Phase 7 --
8 Violet Wind speed 8 Green Speed
Paddlewheel & Sea temp
Color Description
1 - Screen
2 --
3 Black 0 Volts
4 Red & White 5V Supply
5 Yellow Sea Temperature
6 --
7 --
8 Green Speed
www.bandg.com
*988-10709-001*
ENGLISH
Analog Module
Install Guide
Paddle & Sea temp connector
10 K ohm resistor required
between terminal 3 & 5
12345678
Comentários a estes Manuais